PDA

View Full Version : Difficulty with LEDs on Techno PowerBall

user
24-01-2006, 10:36
The display is difficult to read because the gyro besides spinning on the North/South axis, it also spin on the East/West axis. By the time the gyro slows down enough to stop spinning on the E/W axis, the LEDs go out. Am I doing something wrong?

Alan C
user
24-01-2006, 10:36
I seem to have the same issue.
user
24-01-2006, 10:37
Read the other posts in the forum!

This was covered some time ago with some decent hints on how to read it.

Nigel Cornelius
user
24-01-2006, 10:37
just let the ball on the ground/desk or bed (on a soft surface)!

Haiducus