How to dismount?

[user]

A friend stuck a string in the axe of the rotor.
How can I dismout it?

DaPanda

[TrickyDicky]

pull the rubber band off the powerball take out the screws then apply pressure to where the to points where the screws were ( i stand on mine easiest way i find) and you should here a sort of 'crack' bt its no damage just the casing poping open jus pull the shell apart and you can then remove the string with gr8 ease

[Adrena1in]

Happened to me a few times. I just rolled the rotor back in the opposite direction while gently pulling the string to get it out. But if you have to take the Powerball apart then you shouldn't have too much of a problem.

[Alastair V]

This thread is ancient.

[ciperlone]

pull the rubber band off the powerball take out the screws then apply pressure to where the to points where the screws were ( i stand on mine easiest way i find) and you should here a sort of 'crack' bt its no damage just the casing poping open jus pull the shell apart and you can then remove the string with gr8 ease


Thank you for the advice, but I think the powerball dismounts easily if you apply pressure where the screws are not.
I tried your way unsuccessful, and then I tried this way and I did it!

So much plastic garbage around the rotor... :eek:

[Koman]

Oh, I had this, too. It was a little bit complicated. But to open - you just screw it open and remove the band before.