Interchangeable parts???

[caligarinet]

Are all the standard, Neon, Screamer, rotors interchangeable?

Reason I ask, is stupidly dropped my signature, and now its knocking.

Thought if I ordered up another, then I could swap the rotor over, and see if its either the casing, or the rotor.

Quite fancied getting a Screamer anyhow, and also suitably addicted that I don't want to be without one. (And that's after only having one for 3 days. )

Highest Speed, 10888.....I did say I'd only had it for 3 days..

[Armitage]

If you drop your ball the rotor makes bump into platic circle and it knocks it will stop knocking if you rotate it in high speed for some time, im not sure for how long.. but if your ball is vibrating then your rotor is cracked!

About the rotors, Yes you can put neon rotor into screamer and screamer rotor in to signature shell

[caligarinet]

Thanks!!

I'll keep at it, and see if the knocking subsides.

No vibration, so hopefully I've been lucky and not damaged the rotor.

Thanks again,

Paul W

[Killjoy]

Just give it a good 20mins at high rpm, and it smooths it out abit, but general high speed use for a week should have it back as it was, unless you cracked the shell.

If so, contact repairs.

[caligarinet]

a few days on and it still sounds a little rough, knocking has just about disappeared though and speeds still increasing...11755 acheived now.

Repair shop are sending me out a new case (thank you), so will see if that makes any difference.

Kind of hit a barrier at just under 12k, but i think this is probably down to technique rather than any issue with the powerball

[caligarinet]

Replaced the outer shell, support ring and washers...
and it wouldn't spin up


Put the old washers back in,
and now perfectly smooth, and good as new

Thanks to repair team for sending out parts so quickly.